Honeywell HRHM1041 User Manual page 116

116 | Performance Series HQA Digital Video Recorder User Guide
Configuring Net Settings
You can configure the network settings with or without the ATM/POS protocol.
To configure the network settings with the ATM/POS protocol
1.
2.
3.
www.honeywell.com/security
Go to Main Menu > Setting > System > Card Overlay > Net.
On the Net tab, configure the following settings:
• Protocol Select ATM/POS.
• Overlay Mode The Preview and Encode overlay modes are enabled by default.
Clear the check boxes if you want to disable them.
• Overlay Position Select Top Left, Bottom Left, Top Right, or Bottom Right.
• Source IP/Port Enter the source IP and port. The source IP refers to the host IP
address that sends out the information.
• Destination/Port Enter the destination IP and port. The destination IP refers to the IP
address of the device that receives the information.
• Record Channel Select a camera.
• Frame ID Configure up to 6 Frame IDs to ensure valid and legal information.
Enter the StartPosition, Length, and Key. Click Data to enter
Start Position, Length, and Title information for up to four fields,
and then click Save.
Click Apply, and then click Save to save the settings.