Adjust Rate Of Steam Water Pump - Sunbeam EM6910 Service Technician – Training Manual

• Switch OFF unit by pressing POWER button.
• Hold down Memory button (must be held down when in temperature setting
mode).
• Switch On unit by pressing POWER button.
The unit will go into pumping rate setting mode.
•
• In the setting mode, setting function is indicated by Memory green LED.
• In the setting mode, pressing any other buttons will set the temperature lower
relatively to the location of Memory button
• The setting shall be indicated by the selected LED.
Pumping rate of the steam water pump setting is below:
0.2 sec On
0.4 sec Off
Power
• When finished release the Memory button, two beeps sound to indicate the
steam water pump pumping rate is set. The unit will go into starting mode.
• The setting shall be stored in E
EM6910 Café Series Espresso Machine
Adjust pump rate of steam water pump
Factory
Setting
0.5 sec On
0.3 sec On
0.4 sec
0.1 sec Off
0.3 sec Off
On
0.2 sec
Off
Manual One Cup Two
Cups
2
PROM.
0.6 sec On
0.1 sec Off
Memory
Issue: A Page 23 of 48