Descaling Cycle For Both The Coffee And Steam Thermoblocks - Sunbeam PU8000 User Manual

Descaling Cycle for both the Coffee
and Steam Thermoblocks
Scale is a surface build up of minerals that
naturally occur over time in all appliances
that are involved with the heating of water.
Therefore the espresso machine will require
occasional descaling. It is recommended
that the espresso machine is descaled every
4-6 months; this will vary depending on the
frequency of use and water hardness.
1. Remove the water reservoir and rinse
clean. Fill with fresh cold water and
replace the reservoir.
2. Place a large container under the steam
wand so water from the steam wand will
fall into the container.
3. Insert the power cord into a 230-240V
AC power outlet and switch the power
ON.
Important: The steam dial must be closed to
start descaling.
4. Press CLEAN button to choose "ST Clean"
on LCD screen.
5. Turn on the steam dial and allow to run
for 30-60 seconds. Then turn steam dial
off.
6. Pull out the water reservoir, add
Sunbeam descaling tablets. Once tablet
dissolves replace reservoir into position.
7. Turn steam dial on, Press "P" and allow
machine to run for about 7 minutes.
8. Turn steam dial off. Remove water
reservoir and replace contents with fresh
water. Replace reservoir into machine.
Turn steam dial on. Press "P" and allow
machine to run for about 2 minutes.
Turn steam dial off when complete.
Note: If you forget step 8, start the process
again by using clean water from step 5.
23