Electrical Connection - Miele G 7856 Operating And Installation Instructions

,
All electrical work must be
performed by a qualified service
technician in accordance with local
and national safety regulations.
^ Connection should be made via a
suitable isolator which complies with
local and national safety regulations
and the on-off switch should be
easily accessible for servicing.
WARNING
THIS APPLIANCE MUST
BE GROUNDED
^ For technical data see the data plate
or wiring diagram supplied.
The machine must only be operated
with the voltage, frequency and fusing
shown on the data plate.
The data plate (with test certifications)
is located on the rear of the machine
and also behind the plinth panel below
the protective plastic cover.
The wiring diagram is secured to the
inner side below the protective plastic
cover.

Electrical connection

Removing the plinth panel and the
protective plastic cover:
,
Isolate the machine from the
power supply.
^ Holding the plinth panel at both
sides, pull gently outwards from
beneath a and take it out b.
^ To remove the protective plastic cover
unscrew the 2 screws (left and right) c.
To reassemble:
^ Refit the protective plastic cover and
the plinth panel in the reverse order
to which they were removed.
See also the installation diagram
supplied.
WARNING
THIS APPLIANCE MUST BE
GROUNDED
Grounding the machine
A connection screw with the grounding
8
symbol ( ) is provided on the back of
the machine for grounding.
49