Miele G 7856 Operating And Installation Instructions page 37

8. Re-setting all changes back to the
factory default
^ Turn the program selector to "Stop".
^ Turn the machine off.
^ Press and hold the "Display" and
"Start" buttons, at the same time turn
the machine on with the"On/Off"
button.
The display shows the current
program status "P...".
The "Fill/Drain" indicator lights.
^ Press "Extra Drying" seven times.
"E07" (programming level 7) is
displayed.
^ Turn the program selector to any
position (except "Stop").
The display shows either "00" or "PP".
"00" = factory setting
(electronic was not reset).
"PP" = Electronic was reset.
^ If "PP" is displayed press "Display" to
change from "PP" to "00".
^ Press the "Start" button. "SP" is
displayed.
^ Press the "Start" button again. Values
which had been changed are now
reset.
If the hardness level setting in the
water softener had been changed
this will reset to the factory setting of
19 gr/gal (19 °d). This will need to
be adjusted back to the hardness
level in your area.
Programming special functions
37