Regulatory Compliance Statement - Turtle Beach Elite 800X User Manual

Regulatory Compliance Statements for the Elite 800X RX & TX Models
Federal Communications Commission (FCC) Compliance Notices
This section includes the following FCC statements for the Elite 800X RX & TX Models:
• FCC ID: XGB-TB2390 and XGB-TB2391
• Class B Interference Statement
• RF Radiation Exposure & Hazard Warning
• Non-Modification Statement
• Deployment Statement
Class B Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
RF Radiation Exposure & Hazard Statement
To ensure compliance with FCC RF exposure requirements, this device must be installed in a location such
that the antenna of the device will be greater than 2 cm (0.8 in.) from all persons. Using higher gain antennas
and types of antennas not covered under the FCC certification of this product is not allowed. Installers of the
radio and end users of the product must adhere to the installation instructions provided in this manual. This
transmitter must not be co-located or operated in conjunction with any other antenna or transmitter.
Non-Modification Statement
Use only the supplied internal antenna. Unauthorized antennas, modifications, or attachments could damage
the Elite 800X RX & TX Models and violate FCC regulations. Any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate this equipment.
Please contact Turtle Beach for a list of approved 2.4 GHz and 5.0 GHz antennas.
Deployment Statement
This product is certified for indoor deployment only in the 5150 – 5250 MHz band. Do not install or use this
product outdoors in that frequency band in the United States.
Go to Table of Contents
27