Shutting Down The Projector - BenQ ES500 User Manual

Shutting down the projector

1. Press
I
message displays prompting you.
If you don't respond in a few seconds, the
message will disappear.
2. Press
I
POWER indicator light flashes orange,
the projection lamp shuts down, and the
fans will continue to run for approximately
90 seconds to cool down the projector.
• To protect the lamp, the projector will
not respond to any commands during
the cooling process.
• To shorten the cooling time, you can also activate the Quick Cooling
function. See
3. Once the cooling process finishes, the POWER indicator light is a steady
orange and fans stop.
4. Disconnect the power cord from the power putlet if the projector will not be
used in an extended period of time.
5. When Instant Restart is On, users can restart projector immediately within
90 secs after turning off projector. (Projector will maintain 30% of power
during the 90 secs)
When Instant Restart is Off, users need to wait lamp to cool down to restart
the projector. When instant restart is on, quick cooling item will be grey out
• If the projector is not properly shut down, to protect the lamp, when
you attempt to re-start the projector, the fans will run for a few minutes
to cool down. Press Power again to start the projector after the fans
stop and the POWER indicator light turns orange.
• Actual lamp life may vary due to different environmental conditions
and usage.
Operation
42
POWER and a confirmation
I
POWER a second time. The
I
"Quick Cooling" on page 52 for details.