Operation; Starting Up The Projector - BenQ ES500 User Manual

Operation

Starting up the projector

1. Plug the power cord into the projector and
into a power outlet. Turn on the power
outlet switch (where fitted). Check that the
POWER indicator light on the projector
lights orange after power has been applied.
• Please use the original accessories (e.g.
power cable) only with the device to
avoid possible dangers such as electric shock and fire.
• If Direct Power On function is activated in the SYSTEM SETUP: Basic >
Operation Settings menu, the projector will turn on automatically after
the power cord has been connected and power has been applied. See
"Direct Power On" on page 52
• If Signal Power On function is activated in the SYSTEM SETUP: Basic >
Operation Settings menu, the projector will turn on automatically
when VGA signal is detected. See
details.
2. Press
remote control to start the projector. The
POWER indicator light flashes and stays
green when the projector is on.
The start up procedure takes about 30
seconds. In the later stage of start up, a
startup logo is projected.
(If necessary) Rotate the focus ring to
adjust the image clearness.
If the projector is still hot from previous activity, it will run the cooling fan
for approximately 90 seconds before energizing the lamp.
POWER on the projector or
I
I
for details.
"Signal Power On" on page 52 for
Operation 21