Table of Contents
Advertisement
2.7.3 Test Print
This self-diagnostic menu is used to print the test pattern contained in the PU. Other test
patterns are contained in the controller.
1. Enter the self-diagnostic mode
[TEST PRINT] is displayed in the top of the screen.
Press the
(6) key
The
increments the test item and
(2) key
2. The setting items that are applicable to the test print only are displayed in the lower
column of display window. Press the
is displayed. (When the setting value for each item is not required
advance to item 2.)
3. Keep pressing the
item 2. The setup item is displayed in the upper column, and the setting value is displayed
in the lower column of the display window.
(The setting value that is displayed last is applied.)
Pressing the
(4) key
Repeat item 3 as required.
Display
PRINT EXECUTE
TEST PATTERN
TEST CASSETTE
PAGE
COLOR
DUPLEX
MONO SPEED
(Level 1)
to execute.
(2) key
or the
key, and press the
(2) key
(8)
determines the setting value, and the screen returns to item 2.)
Setup Value
0
TRAY1
TRAY2
MPT Tray
0000
ON
OFF
2 PAGES STACK
OFF
1PAGES STACK
LOW
HIGH
and press the
(2) key
decrements the test item.
(8) key
or the
until the corresponding item
(8) key
(6) key
Function
Pressing the (4) key starts
printing/Pressing the (#) key ends
printing (in page unit).
0 = White paper print
1 to 7 Refer to next page. (Pattern print)
8 to 15 = White paper print
Select the paper feed source.
If TRAY2 is not installed, TRAY2 is not
displayed.
Setting the number of test prints.
Selecting color or monochrome print.
ON is specified, ON/OFF setting for
each color appears.
Duplex print is executed with two sheets
stack.
Duplex print OFF select
Duplex print is executed with single
sheet stack.
Selecting monochrome print speed.
LOW: 30ppm
HIGH: 34ppm(A4),33ppm(Letter)
or
until
(8) key
[Default
setting],
at the item that is set in
35
Advertisement
Table of Contents
