Coin Operation Unit - Miele T 6251 Operating Instructions Manual

Selecting a programme
Important: Before drying bedding a re-pro-
gramming of the standard options must be
A
carried out with /
(see table at the top of page 19).
- See pages 16 - 18 for conditions and
examples for reprogramming. -
Note: The duration of the
is set ex-works to 20 minutes, (the standard
option) (see table at the top of page 19).
A change to the duration of the programme
can be made by reprogramming for
"with heating (followed by Cooling down) Pro-
gramme 11 ", (see table at the top of page 19).
If required also select the "l Buzzer"
functions.
h
Press in the "
- The drying programme selected now
starts.-
Note
The " l Check fluff filter" light comes on if the
fluff filter needs to be cleaned. Clean the filter
as soon as the programme has finished. (see
page 20 for more details).
On gas heated dryers the " y & Re-set" light
comes on if there is an ignition fault. The igni-
tion fault can be resolved by waiting for at
least one minute, then pressing the " y & Re-
set" button. If ignition problems become more
frequent contact the Service department.
The washing must not be taken from the dryer
before the drying programme has finished, ie,
the cooling down phase must be com-
pleted.
If hot laundry items are stacked or packed
they can be liable to auto-combustion.
If the laundry is rinsed with hot water in the
final rinse, the residual heat in the laundry,
together with the reduced residual moisture
content, will lead to shorter processing times
and save energy.
1 A 2 A 4
, / and /
C !
/ programme
B
/
Start" button.
The end of the drying programme is indi-
cated by the "
lighting up and the buzzer sounding if selected.
Turn the programme selector to "
Open the drum door.
Remove the washing.
If the dryer is not going to be used again in
9
the near future:
Press the " s On/Off" button to switch off
the machine.
Switch off at the site main switch.
Clean the fluff filter.

Coin operation unit

Drying with coin operation unit
C 4031 / C 4051 / C 5002
C 4060 / C 4065 / C 4070
It is important to follow the sequence below as
otherwise coins or tokens could be lost and
not credited.
1. Load the laundry and close the door.
2. Press in the " s On-Off" button.
3. Select a programme.
4. If required select the "
ture" and/or " l Buzzer" functions.
5. Insert coins or tokens.
6. Press in the "
Note
Empty the coin box daily. This avoids a build
up of coins or tokens in the box which could in-
terfere with operation.
14
~
r Anti-crease / End" light
L
Low tempera-
h
Start" button.
«M.-Nr.04989220/02 - GB - »
r
End".