Cub Cadet FT24 R Operator's Manual page 8

4. Remove the hex bolt and cupped washer from the right
side of the frame. Hold the cable guide bracket on the left
side of frame as it will fall when the bolt is removed. Step 1
in Figure 3-3.
5. Insert the handle into tiller frame as shown. Step 2 in
Figure 3-3.
6. Insert the bolt through the cupped washer, frame, handle
and into the cable guide bracket (note the notch in the
cable guide bracket goes over the flange on the frame.)
Step 3 in Figure 3-3.
7. Tighten the bolt securely after securing the handle brace as
seen in Figure 3-4.
8. Locate the carriage bolt, bell washer and hand knob
packed with your tiller.
8 S 3— A
ection SSembly
1
2
Figure 3-3
Hand Knob
Carriage Bolt
Bell Washer
Handle Brace
Figure 3-4
& S -U
et p
9. Insert the carriage bolt through the welded bracket on the
handle, bell washer, handle brace and into the hand knob.
See Figure 3-4.
10. Select one of the three handle height positions (three notches
in the welded handle bracket) and tighten the hand knob
to secure the handle in the desired position. See Figure 3-4.
Return to the lower handle and tighten the hex bolt securely.
Depth Gauge
1. Remove the two screws from the depth stake assembly.
See Figure 3-5.
3
2. Insert the depth stake assembly into the frame and reinstall
the two screws removed earlier. Tighten the hex bolts
securely. See Figure 3-6.
Depth Stake
Assembly
3. Secure the pin with the clip removed earlier. The depth
stake can be placed at various positions. For setup
purposes it is suggested that the depth stake be assembled
with the stake just above or level with the ground surface.
For further instructions on the Depth Stake refer to the
Operation Section of this manual.
Depth Stake
Assembly
Screws
Figure 3-5
Screws
Figure 3-6