Cub Cadet GC145 Operator's Manual
  1. Manuals
  2. Brands
  3. Cub Cadet Manuals
  4. Tiller
  5. GC145
  6. Operator's manual

Cub Cadet GC145 Operator's Manual

4-cycle cultivator
Hide thumbs Also See for GC145:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

Quick Instructions to
Assemble the Unit
For complete instructions, refer to the
Assembly Instructions section of this
manual.
Quick Instructions
to Start the Unit
For complete instructions, refer to
Starting/ Stopping Instructions section
of this manual.
IMPORTANT: READ OPERATOR'S MANUAL THOROUGHLY AND FOLLOW THE SAFE OPERATION PRACTICES BEFORE OPERATING THE UNIT.
NEED HELP?
PART NO. 769-05376 P00
Operator's Manual
Read and understand all instruction, warning and danger labels on the unit.
Loosen the handlebar knobs and swing the
handlebars up into the operating position. Taking
care not to pinch any cables or wires, tighten the
knobs to secure the handlebars.
Tip the unit so that the back of the engine is in
a horizontal position. Remove the oil fill plug
from the crankcase and pour the entire bottle
of 4-cycle oil into the oil fill hole.
NOTE: Do not mix gas and oil
Remove cotter pin from the clevis pin and slide
clevis pin out of tailpiece bracket. Slide the wheel
support bracket up or down to the desired tine
depth. Place the clevis pin through the aligned holes
and secure with clevis pin and cotter pin.
Press primer bulb 10 times.
Move blue choke
lever to Position 2.
CALL 1-877-282-8684 IN U.S. OR 1–800–668–1238 IN CANADA
DO NOT RETURN THIS PRODUCT
For Assistance please call 1-877-282-8684 (U.S.) or 1-800-668-1238 (Canada)
or visit www.mtdproducts.com or www.mtdproducts.ca
Deeper
Shallower
Place choke lever in
Stand in the
Position 1.
starting position.
Pull the rope 3 to 5
While continuing to
times to start. Run
squeeze the throttle
engine for 30-60
control, move the blue
seconds to warm up.
choke lever to Position 3.
GC145
4-Cycle Cultivator
SQUEEZE and HOLD throttle
Pull the rope
control for ALL further steps.
5 times.
DIDN'T START?
Repeat these instructions.
If engine still fails to start, refer
to the Starting/ Stopping
Continue warming for an
instructions section of this
manual for additional starting
additional 60 seconds.
and troubleshooting information.
During this time the unit
may be used.
5 X
(11/09)

Advertisement

Table of Contents
loading

Related Manuals for Cub Cadet GC145

Summary of Contents for Cub Cadet GC145

  • Page 1 GC145 4-Cycle Cultivator Operator’s Manual Read and understand all instruction, warning and danger labels on the unit. Loosen the handlebar knobs and swing the handlebars up into the operating position. Taking care not to pinch any cables or wires, tighten the knobs to secure the handlebars.

  • Page 2: Table Of Contents

    SERVICE INFORMATION RULES FOR SAFE OPERATION TABLE OF CONTENTS • Always stop the engine and allow it to cool before filling the fuel tank. Never remove the cap of the fuel tank, or add fuel, when the engine is hot. Never operate the unit without the fuel cap securely in place. Service Information .

  • Page 3: Know Your Unit

    KNOW THE UNIT OIL AND FUEL INFORMATION APPLICATIONS WARNING: Add fuel in a clean, level and well ventilated outdoor area. Wipe up any spilled fuel immediately. • Cultivating sod and light to medium soil Avoid creating a source of ignition for spilled fuel. Do not start the engine until fuel vapors dissipate. •...

  • Page 4: Maintenance & Repair Instructions

    MAINTENANCE AND REPAIR INSTRUCTIONS MAINTENANCE AND REPAIR INSTRUCTIONS CHECKING THE OIL LEVEL • Both rocker arms move freely, and both valves are closed. If these statements are not true, repeat this step. WARNING: To prevent extensive engine wear and damage to the unit, always maintain the proper oil 7.

  • Page 5: Specifications

    SPECIFICATIONS SERVICE TECHNIQUE TABLE DES MATIÈRES ENGINE* Engine Type..............Air-Cooled, 4-Cycle Service technique .

  • Page 6: Familiarisez-Vous Avec Votre Appareil

    CONSIGNES DE SÉCURITÉ CONSIGNES DE SÉCURITÉ ALERTES DE SECURITE POUR LES APPAREILS A ESSENCE SYMBOLE SIGNIFICATION AVERTISSEMENT : L'essence est extrêmement inflammable et ses vapeurs peuvent • SURFACE CHAUDE AVERTISSEMENT : exploser si on y met le feu. Veuillez prendre les précautions suivantes. Ne touchez pas un silencieux ou un cylindre chaud.

  • Page 7: Instructions De Démarrage Et D'arrêt

    INFORMATIONS SUR L'HUILE ET LE CARBURANT INSTRUCTIONS D’ENTRETIEN ET RÉPARATIONS TYPE CARBURANT RECOMMANDÉ PROGRAMME D'ENTRETIEN AVERTISSEMENT : AVERTISSEMENT : Pour éviter tout accident, n’effectuez jamais l’entretien ou des réparations Il a été prouvé que l’utilisation de carburant contenant plus de 15% d’éthanol quand l’appareil fonctionne.

  • Page 8: Tableau De Dépannage

    INSTRUCTIONS D’ENTRETIEN ET RÉPARATIONS TABLEAU DE DÉPANNAGE Nettoyage du filtre à air LE MOTEUR REFUSE DE SE METTRE AU RALENTI L'état du filtre à air est très important pour le fonctionnement de l'appareil. Un filtre à air sale restreint le débit d'air et CAUSE SOLUTION affecte le mélange de carburant/air.

  • Page 9: Caractéristiques

    LLAMADAS A APOYO AL CLIENTE NORMAS PARA UNA OPERACION SEGURA INDICE DE CONTENIDOS • Almacene el combustible solamente en recipientes diseñados y aprobados específicamente para el almacenamiento de dichos materiales. Llamadas a apoyo al cliente ............9 •...
  • Page 10 NORMAS PARA UNA OPERACION SEGURA INFORMACION DEL ACEITE Y DEL COMBUSTIBLE Definición de los gasolinas de mezcla SYMBOLE SIGNIFICADO Las gasolinas actuales con frecuencia son una mezcla de gasolina y uno o más oxigenantes como el etano, el metanol • CONTROL DEL OBTURADOR o el MTBE (éter).
  • Page 11 INSTRUCCIONES DE MANTENIMIENTO Y REPARACIÓN INSTRUCCIONES DE MANTENIMIENTO Y REPARACIÓN Una mezcla incorrecta o vieja de combustible es en general el motivo por el cual la unidad no funciona PROGRAMA DE MANTENIMIENTO adecuadamente. Drene y vuelva a llenar el tanque con combustible nuevo y bien mezclado antes de hacer ningún ADVERTENCIA: Para evitar lesiones personales graves, nunca realice mantenimiento ni reparaciones ajuste.
  • Page 12 INSTRUCCIONES DE MANTENIMIENTO Y REPARACIÓN ESPECIFICACIONES 3. Espere que el motor se enfríe. Retire la bujía de encendido y coloque alrededor de 30 ml (1 onza) de cualquier MOTOR* aceite para motor de 2 ciclos de buena calidad dentro del cilindro. Tire de la cuerda de arranque lentamente para Tipo de motor .
  • Page 13 NOTE...
  • Page 14 NOTES...
  • Page 15 NOTES...

  • Page 16: Warranty Information

    C. Cub Cadet LLC n'accorde aucune garantie pour les produits vendus ou exportés des États-Unis d'Amérique, de leurs possessions et territoires, exception faite en ce qui concerne les produits vendus par l'intermédiaire de ses canaux agréés de distribution à l'exportation.

Table of Contents