Set Analog Clock Hourly/Twice Daily Correction; Soft Reset; Reset Configuration; Set Stepper Hand Position Analog Clock - Symmetricom ND-SERIES User Manual

Set Analog Clock Hourly/Twice Daily Correction

[Note: This menu item feature has been retained for backward compatibility with a discontinued model
of analog clock with AC synchronous only. This feature does not apply to the stepper motor analog
clock, or digital clocks.]

Soft Reset

The network clock may be restarted with a soft reset command to allow the device to clear its current
communications buffer and re-initialize its processing, includes re-requesting of a DHCP address. This
feature is intended to allow the user to remotely attempt to clear issues with the unit. This feature does
not restore the unit to its factory default state. This command is essentially equivalent to the right click
menu item "Reset Device" under WinDiscovery and the automatic soft restart built into the clock.

Reset Configuration

The network clock may be reset from telnet. Use this command sparingly as it will reset the unit to
initialize and utilize DHCP IP addressing mode by default, and will likely change the IP address of the
unit, making the communication via telnet impossible until the new IP address of the unit is configured
or known.
If this command fails to clear an issue with the clock, a hard reset may be in order to return the unit to its
factory default state. In certain [rare] instances it may become necessary to access the configuration
reset switch to return the network clock to its factory default settings or to recover from a non-
responsive condition. Consult the section "Reset Factory-Default Configuration" under the
"Configuration" section of this manual.

Set stepper hand position analog clock

]
[Note: this menu items applies to analog stepper motor models only.

Get Status stepper analog clock

Provides status information specific to the analog stepper motor clock.
[Note: this menu items applies to analog stepper motor models only]

Enable/Disable User Control of Digital Display

The digital display clock may be used in a special user control mode allowing specific
time/date/character information to be displayed, other than the actual time display mode based on the
NTP server time. This mode is password protected.
[Note: this menu items applies to digital time display models only]
Enter X to exit the Telnet menu. This will disconnect your Telnet session from the clock.
®
ND Clocks User Manual - Rev 2.0.1 Sep-08 28 Symmetricom , Inc.