Maintenance
Water inlet valve and inlet valve ter
To prevent blockage to the water supply by ingress of foreign
substances, clean the water inlet valve and inlet valve
Moving the machine
Remove the back cover.
Remove the blanking plugs.
Tighten the bolts with a spanner.
Replace the back cover.
Long periods of disuse
not used.
Display Codes
Codes
Causes
Err1
Door is not properly shut.
6 minutes.
Err3
Temperature sensor not properly
connected or damaged.
Err4
Heater error (Appears at the end of a
cycle).
Err5
Water level not met in 8 minutes.
The height of the drain hose is below 80
cm.
The drain hose is in water.
regularly.
ll out the electrical plug and turn o
moisture and odors. Let the door open while
Shut the door properly, and then press the
lter and check the drain hose
contact the maintenance personnel.
Contact the maintenance personnel.
Contact the maintenance personnel.
Make sure that tap is turned on, and water
pressure is normal.
maintenance personnel.
Install drain hose within 80-100 cm of
height.
Make sure the drain hose is not in water.
17
he water