Maintenance
Water inlet valve and inlet valve
To prevent blockage to the water supply by ingress of foreign
substances, clean the water inlet valve and inlet valve
Moving the machine
Remove the back cover.
Remove the blanking plugs.
Insert the plastic stabilizers and the transportation bolts.
Tighten the bolts with a spanner.
Replace the ba
ck cover.
Long periods of disuse
If the appliance is left idle for a longer period, pull out the electrical plug and turn off water supply.
Open the door to prevent formation of moisture and odors.
Let door open while not used.
Before next usage check carefully power cord, water inlet and drain hose. Make sure everything is
properly installed and without leackage.
Display Codes
Codes
Causes
6 minutes.
Door is not properly shut.
E2
F3
Temperature sensor not properly
connected or damaged.
F4
Heater error (Appears at the end of a
cycle).
E4
Water level not met in 7 minutes.
The height of the drain hose is below 80
cm.
The drain hose is in water.
r
regularly.
Clean the pump filter and check the drain
hose
contact the maintenance personnel.
Shut the door properly, and then press the
Contact the maintenance personnel.
Contact the maintenance personnel.
Make sure that tap is turned on, and water
pressure is normal.
maintenance personnel.
Install drain hose within 80-100 cm of
height.
Make sure the drain hose is not in water.
17