Moving The Machine; Long Periods Of Disuse; Display Codes - Haier HW60-1279 User Manual

Maintenance
To prevent blockage to the water supply by ingress of foreign
substances, clean the water inlet valve and inlet valve filter regularly.
Maintenance or service wash
A maintenance wash is done to clean the washing machine out by running
a high-temperature (90°C Co on) program once a month. The high temperature
kills off bacteria and unwanted fungal growth. A service (or maintenance) wash involves pu ng the
washing machine on the ho est wash (90°C Co on Wash) with only the detergent inside - and no laundry.
If you normally use a washing machine detergent that doesn't contain bleach, then buy some detergent
that does, and use it for your maintenance washes. This will help kill off bacteria and prevent black mould
and grease.
Tip: Look for something like, "bleaching agents" in the ingredients. Do not put cleaning bleach (for example
"Domestos") in the washing machine this will damage the machine. There are certain types of bleach
example oxygen bleaches like "Vanish" that are appropriate for laundry. To check if your washing machine
is being badly affected, carefully examine the inside of the door seal for slime. Pull the lip in front of the
drum and look underneath on lip of the tub as it can accumulate a slime, which causes smells, and rots
the seal.

Moving the machine

If the machine is to be moved to a distant lo
in on to prevent damage as shown below.
Remove the back cover.
Remove the blanking plugs.
Insert the synthe c stabilizers and the transpo
Tighten the bolts with a spanner.
Replace the back cover.

Long periods of disuse

If the washing machine is l
supply. Open the washer door to prevent form on of moisture and odors. Let the door open while
not used.

Display Codes

Display Codes and Special func ons
Codes Causes
Err1 Door is not properly shut.
Err2 Drainage error, water not emp
6 minutes.
Err3 Temperature sensor not properly
connected or damaged.
Err4 Heater error (Appears at the end of a
cycle).
Err5 Water level not met in 8 minutes.
The height of the drain hose is below 80
cm.
The drain hose is in water.
on, replace the transpo
on bolts.
idle for a long period, pull out the electrical plug and turn off the water
within
17
on bolts removed before
Solu ons
Shut the door properly, and then press the
Start/Pause bu on.
Clean the filter and check the drain hose
for blockage. If error s l exists, please
contact the maintenance personnel.
Contact the maintenance personnel.
Contact the maintenance personnel.
Make sure that tap is turned on, and water
pressure is normal.
If problem s ll exists, please contact the
maintenance personnel.
Install drain hose within 80-100 cm of
height.
Make sure the drain hose is not in water.