Table of Contents
Advertisement
Setting the Clock
To set the time:
1. Press the power/volume knob to turn the system on.
2. Press the CONFIG hard key.
H
3. Press the
(clock) screen button.
4. Select the 12hour or 24hour screen button to
display the time in standard or military time.
5. Select the AM or PM screen buttons.
6. Select the appropriate time zone screen button.
7. Select the Daylight Saving Time screen button,
if necessary.
8. Press and hold the hour and minute arrow buttons
to increase or to decrease the time or press the
GPS TIME screen button to reset radio time to
GPS time.
The radio uses the GPS satellite to set the time.
The vehicle needs to be in an open area to receive
the signal. See "Clock" under Configure Menu on
page 2-59 for more information.
1-8
Setting the Region, Entering an
Address and Point of Interest, and
Storing a Home Destination and Preset
Destinations
Before entering an Address, Point of Interest, Home, or
Preset Destination, select the appropriate region that
contains the final destination. The vehicle must be
stopped to perform this operation.
Setting the Region
To set the region:
1. Press the power/volume knob to turn the system on.
2. Insert the DVD map disc. See "Installing the Map
DVD" under Maps on page 2-4 for more information.
A notice may appear. Touch the I agree screen
button to proceed.
3. Press the ROUTE hard key.
4. Press the Region screen button.
5. Select the appropriate region numbered screen
button that contains the final destination.
The system returns to the DESTINATION ENTRY
screen. See "Region" under Destination on page 2-40
for more information.
Advertisement
Table of Contents
