Removal Of Cast Sides; Surround And Trim Set - Cast - Quadra-Fire MTVI-E2-MBK Installation Manual

3 inch
high Set
5 inch
high Set
Install Front Trim Last,
Corner Overlap Side
Trim Pieces
Figure 19.1
9 attachment holes - 3 on
each side and 3 in the front
Figure 19.2
D. Removal of Cast Sides
Remove the right side panel by releasing the upper, spring-
loaded latch. Access the latch through the upper panel vent
holes. The cast panel should fall forward. Lift it out of its
lower nest and set the panel aside. You may need to discon-
nect the dial control wire harness.
Figure 19.3 - Shown with Cast Panel Set
June 18, 2014
Attach Trim to Insert from
inside Insert.
3 in
Basic
Cast
5 in
Attach Trim to Base
from underneath
Location of Latch
for Removing
Cast Sides
Lower the leveling
bolts if necessary to
keep the insert level
when installing the
Hearth Support.
E. Surround and Trim Set - Cast
Included in Surround Kit: (2) side panels, left and right;
(1) panel top; (1) fastener package.
Included in Cast Trim Kit: (2) cast trim legs, left and right;
(1) cast trim header; (2) cast trim footers, left and right; (1)
fastener package.
Tools Needed: Powered Phillips head screw driver
1. Remove contents from box being careful not to scratch or
damage the cast trim pieces.
2. Lay the surround set face down on protective covering to
prevent scratching the painted surface.
3. Secure the surround legs to top panel with the screws
provided.
4. Now bend the tabs down toward the backside of the panel
set, 5 on top and 2 on each leg. Leave the panel set face
down. Figure 19.4
5. Place the corresponding cast trim pieces ( 2 cast trim legs
and 1 cast trim header) underneath the panel set, also face
down.
6. Place washer provided over tab and secure the trim and
panel together with screw. Continue for all tabs.
7. Secure cast footers with screws.
8. Remove both left and right cast sides from insert. See
Figure 19.3.
9. Carefully slide surround and trim over the top of the
insert into place matching the mounting holes on the
panel with the mounting holes on the insert. Secure with
screws provided.
1. Screw panels
together
Figure 19.4
Figure 19.5- Completed View
7082-131C
MT VERNON E2 INSERT
2. Bend tabs down
3. Install Cast Trim Header
1. Screw panels
together
2. Bend tabs
down
19