Removing The Front Usb Connector Assembly - IBM x3100 M5 Type 5457 Installation And Service Manual

Operator information
panel assembly
Figure 162. Operator information panel assembly installation for 5U server model with
hot-swap power supplies
10. Install the lower bezel (see "Replacing the lower bezel" on page 190).
11. Install and lock the side cover (see "Replacing the side cover" on page 182).
12. Reconnect the external cables and power cords; then, turn on the attached

Removing the front USB connector assembly

Use this information to remove the front USB connector assembly
To remove the front USB connector assembly on 4U server models with
non-hot-swap power supplies, complete the following steps. For the 5U server
model with hot-swap power supplies, please see the next sub-section.
250
System x3100 M5 Type 5457: Installation and Service Guide
5. Reroute and connect the operator information panel assembly cable to the
system board (see "System-board internal connectors" on page 30 for the
location of the operator information panel assembly connector).
6. Install the power-supply cage and the power supplies (see "Replacing the
hot-swap power supply cage" on page 297 and "Replacing the hot-swap
power supply" on page 264).
7. Push the drives in bay 1 and bay 2 into the drive bays (see "Replacing the
DVD drive" on page 207 and "Replacing the tape drive" on page 213 for more
information).
8. Stand the server back up in its vertical position.
9. Install the upper bezel (see "Replacing the upper bezel" on page 192).
devices and turn on the server.
1. Read the safety information in "Safety" on page vii and "Installation
guidelines" on page 35.
2. Turn off the server and all peripheral devices; then, disconnect the power
cords and all external cables.
3. Remove the bezel (see "Removing the bezel" on page 40).
4. Carefully turn the server on its side so that it is lying flat, with the cover
facing up.
Attention: Do not allow the server to fall over.
5. Remove the side cover (see "Removing the side cover" on page 38).
6. Remove the air baffle (see "Removing the air baffle" on page 39).
7. Disconnect the front USB cable from the system board by pushing on the
latch, and note the routing of the cable (see "System-board internal