11. Press in the tabs ( 1 ) with the tip of a flat-blade screwdriver until the housing
To install the blower housing, reverse the previous steps, making sure that the two
tabs are inserted into the notches on the front of the chassis.
Front USB connector assembly
Complete the following steps to remove the front USB connector.
Note:
1. Turn off the server.
2. Disconnect all external cables and power cords from the back of the server.
3. Remove the bezel (see "Removing the bezel" on page 16).
4. Remove the server cover (see "Removing the left-side cover" on page 14).
releases and tilts up ( 2 ); then, pull the housing out of the two notches on the
front of the chassis and lift ( 3 ) the housing out of the server.
v Read "Installation guidelines" on page 11"Installation guidelines" on page
11.
v Read Appendix B, "Safety information," on page 153.
v Read "Handling static-sensitive devices" on page 12.
Chapter 4. Service replaceable units
73