Table of Contents
Advertisement
3.3.1 Installation of the Connection Pipe
Before wiring and piping, please remove the filter after opening the glass panel.
1.
As shown in Fig.2,take out the decorative strip at position 1 and then unscrew the screws. Remove
the screws fixing the filter after opening the glass panel. At last take out the filter along the arrow
direction at position 3.
2.
During piping and wiring in the left and at the rear side, the attached accessories should be used, as
shown in Fig.4。
Models
TGS-71FSA-E
TGS-100FSA-E
TGS-140FSA-E
3.3.2 Installation of the Drainage Pipe
1.
Make sure drainage pipe is led outdoors (discharge side).
2.
Butt-joint drainage pipe in the unit with blowing drainage pipe and fix them with insulated tape.
3.
If the drainage pipe should be wrapped with heat-preservation material (at least 9mm thickness),
and then wrap it with tape to prevent air from entering into the pipe, which will cause
condensation.
4.
After connecting, check if water can discharge properly or if there is any leakage. (As shown in
Fig.5)
3.4 Installation of the Baffle
Please install it after installation of connection pipe and drainage pipe according to Fig.8
1） 1. Loosen the screws and adjust the baffle position up and down to clamp connection pipe/drainage
pipe as much as possible.
2） 2. Tighten the screws.
3.5 Electrical Connection
3.5.1 Precautions for Electrical Connection
1.
It should be connected with the special earth device on the building and be installed by the
professional personnel. There should be enough capacity of creepage protector and air switch.
(Please refer to the following table)
2.
The power supply must use the rated voltage and special circuit.
Gas Pipe（mm/inch）
Φ16
5/8
Φ16
5/8
Φ16
5/8
Fig.8
5
Liquid pipe（mm/inch）
Φ9
Φ9
3/8
Φ9
3/8
3/8
Advertisement
Table of Contents
