Table of Contents
Advertisement
FAN button
TIMER BUTTON
TEMP.display button
HEALTH|SAVE
button
TURBO button
In Stationary swing mode, press this button
down swing as show in below:
When up and down swing louver is working, when turn off the unit,
the siwng louver will immediately stop at current position.
shows up and down swing louver swings back and forth as show in
the above figure.
Press this button once, fan speed will change as below:
Low fan
Middle fan
High fan
Note: Under the Dry mode, the fan speed isn't adjustable, low fan
speed is imperative, but when operating this button, the wireless
remote control will send this signal.
On the status of the unit on, press this button to set timer off. On the
status of the unit off, press this button to set timer off. Press this key
once, words Hour on(off) will appear and flicker. In which case,
press +/- button to adjust time (press+/- button continuously to
change timing value quickly the setting time range is from 0.5 to 24
hr;
Press this key once again to fix the time, then remote controller will
send out the signal immediately and hour on/off will stop flickering.
If the time of that no press timer button under flickering status is
more than 5s,the timer setting will quit. If the timer has been set,
press this button once again to quit it.
After
powered
on,
defaulted,(According to customer requirements to display, if there
are no requirements, the presetting temperature displaying is
defaulted, there is no signal display on the remote control).Press this
button,(display
),display the presetting
temperature;(display
temperature,(display
display status is indoor ambient temperature when received other
remote control signal, then will display presetting temp ,5s later
return to ambient temp. display.
Other models haven't this function. But pressing this button, the main
unit will click and keep the original status.
HEALTH function: there is no this function for this unit. If press this
key, the main unit will click, but it also runs under original status.
Save energy function: this unit has no this function, press this button,
the main unit will click, "SE" will be displayed on the LCD of
wireless remote control, fan speed automatically rotates, when
repress this button, the fan speed will run at previous setting fan
speed.
Set turbo on or off (the characters of turbo will appear or disappear)
by pressing this key under cooling or heating mode. Once energized,
the unit will be defaulted to be turbo off. This function can not be set
12
displaying
presetting
),display indoor ambient
),display ambient temperature, If current
,the angle for Up and
temperature
is
Advertisement
Table of Contents
