True TUR-24-R/L-SS-A Installation Manual page 52

WINE SHELVING ADJUSTMENT
The glide out wine shelves in TBC, TWC and TWZ-DZ
models consist of 3 pieces. These pieces are the wire
wine rack and 2 mounting bracket/glide assemblies (one
for the hinge side and one for the non-hinge side).
To remove the wine shelf, pull up on the front of the wine
rack and it will separate from the 2 mounting brackets.
The 2 mounting brackets may now be removed from the
pilasters by lifting straight up then pulling the brackets out
of the pilasters.
Note when reinstalling the brackets, the bracket with the
larger vibration bumper must be installed on the same
side of the cabinet as the door hinge. When reinstalling
the wine rack, be sure that the back of the rack hooks
underneath the tab on the glide.
46 True Professional 24 Series Installation Guide
The tab on the front of the glide must also fit securely in
the gap between the handle and the rack (see illustration).
If the fit is too tight, you may need to loosen the screws
on the back of the handle to increase the gap.
The wine shelves are held securely by the anti-vibration
bumpers. If there is too much play side-to-side, tighten
the bumpers against the compartment walls by rotating
with your fingers.
anti-vibration
bumpers