Configuring General Setup Using The Control Panel; Getting Information About The Printer; Configuring System Settings - Xerox Phaser 6022 User Manual

Installation and Setup
Configuring General Setup Using the Control
Panel
This section includes:
•

Getting Information About the Printer ...................................................................................................................... 50

•

Configuring System Settings ........................................................................................................................................... 50

Getting Information About the Printer
1. At the printer control panel, press the Menu button.
Note: To navigate through the menu, use the up or down arrow buttons.
2. Navigate to Information Pages.
To scroll through the information pages, use the Up or Down arrows.
3.
4. To print a specific information page, press OK.
Configuring System Settings
You can use this menu to configure general settings of the printer, such as Power Saver timers, clock
settings, and alert settings.
Accessing the System Setup Menu
1. At the printer control panel, press the Menu button.
Note: To navigate through the menu, use the up or down arrow buttons.
Use the Up and Down arrows to navigate to Admin Menu, then press OK.
2.
Navigate to System Setup, then press OK.
3.
Configuring Power Saver Mode
You can set the time the printer spends idle in ready mode before the printer transitions to a lower
power level.
There are two levels of Power Saver mode.
• Mode 1 (Low Power): The printer shifts from Ready mode to Low Power mode to reduce standby
power consumption.
• Mode 2 (Sleep): The printer shifts from Low Power mode to Sleep mode for a greater reduction in
power consumption.
® ®
50 Xerox Phaser 6022 Printer
User Guide