Garmin GPSMAP 4008 Owner's Manual page 85

Configuring the Navigation Data Bar on the Radar Screen
You should show the navigation data bar before you configure it
1. From the Home screen, select Radar.
2. Select Cruising, Harbor, or offshore mode.
3. Select Menu > Radar Setup > Data Bars > Navigation > Data Bar Setup.
4. Complete an action:
• Select Route Leg. Select on to show waypoint velocity made good when navigating a route or an Auto
Guidance line.
• Select Next turn > Distance to show next-turn data based on distance.
• Select Next turn > time to show next-turn data based on time.
• Select Destination, and select Distance, time to Destination, or Arrival to indicate how the
destination data appears.
Fishing, Fuel, and Sailing Data Bars
Data Bar Data Shown
Fishing Depth, water temperature, and water speed
Fuel Fuel rate, remaining fuel, range, and fuel economy
Sailing Water speed, wind speed, wind angle, and wind velocity made good (VMG)
Showing the Fishing, Fuel, and Sailing Data Bars on the Radar Screen
The fishing, fuel, and sailing data bars appear in a row across the bottom of the Radar screen. Only one of
these three data bars can appear at a time.
1. From the Home screen, select Radar.
2. Select Cruising, Harbor, or offshore mode.
3. Complete an action:
• Select Menu > Radar Setup > Data Bars > Fishing > on to show the Fishing data bar.
• Select Menu > Radar Setup > Data Bars > Fuel > on to show the Fuel data bar.
• Select Menu > Radar Setup > Data Bars > Sailing > on to show the Sailing data bar.
Note: When you show any one of these three data bars, the other two data bars are hidden automatically.
Setting True or Apparent Wind for the Sailing Data Bar
You should show the sailing data bar before you configure it
1. From the Home screen, select Radar.
2. Select Cruising, Harbor, or offshore mode.
3. Select Menu > Radar Setup > Data Bars > Sailing.
4. Complete an action:
• Select Wind > Apparent to show the flow of air experienced while on a boat in motion.
• Select Wind > true to show the flow of air experienced while on a stationary boat.
Wind VMG and Waypoint VMG in the Data Bars
See "How Wind VMG and Waypoint VMG Appear in the Data Bars"
Showing the Compass Tape on the Radar Overlay Screen
The compass tape data bar appears in a row across the top of the Radar Overlay screen, above the navigation
data bar. It shows the current heading, and an indicator that shows the bearing to the desired course appears
while navigating.
1. From the Home screen, select Radar.
2. Select Radar overlay.
3. Select Menu > Setup > Data Bars > Compass tape > on.
GPSMAP 4000/5000 Series Owner's Manual
®
(page 80).
(page 81).
(page 58).
Radar
81