Garmin GPSMAP 4008 Owner's Manual page 109

Configuring Waypoint Identification
You can configure how the chartplotter provides waypoint identifiers.
1. From the Home screen, select Configure > Communications > NMeA 0183 Setup > Waypoint iDs.
2. Select Names or Numbers.
Resetting NMEA 0183 Communication Default Settings
You can reset NMEA 0183 settings to their default values.
From the Home screen, select Configure > Communications > NMeA 0183 Setup > Defaults > oK.
Viewing NMEA 0183 Diagnostic Information
The NMEA 0183 Diagnostics screen is a troubleshooting tool used by installers to verify that NMEA 0183
data is being sent across the system.
From the Home screen, select Configure > Communications > NMeA 0183 Setup > Diagnostics.
NMEA 2000
GPSMAP 4000/5000 series chartplotters are NMEA 2000 certified and can receive data from a NMEA 2000
network installed on the boat to show specific information, such as depth, speed, water temperature, wind
speed and direction, and engine data.
You can also name your engines and tanks so that you can better identify their location on the boat.
To connect a GPSMAP 4000/5000 series chartplotter to an existing NMEA 2000 network and to see a list of
supported NMEA 2000 PGN numbers, see the GPSMAP 4000/5000 Series Installation Instructions.
Viewing a List of NMEA 2000 Network Devices
You can view the devices connected to the NMEA 2000 network.
1. From the Home screen, select Configure > Communications > NMeA 2000 Setup > Device List.
2. Select a device for a list of options.
Labeling Engines as Numbers
From the Home screen, select Configure > Communications > NMeA 2000 Setup > Label Devices >
Change engine Labels > Use Numbers.
Labeling Engines as Names
1. From the Home screen, select Configure > Communications > NMeA 2000 Setup > Label Devices >
Change engine Labels > Choose Names.
2. Select the engine you want to name.
3. Select the location of the engine: Port (P), Center (C), Starboard (S), Fore (F), or Aft (A).
4. Select the label you want to use for the engine.
5. Repeat steps 2 through 4 to label additional engines, if applicable, then select Done.
Labeling Tanks as Numbers
1. From the Home screen, select Configure > Communications > NMeA 2000 Setup > Label Devices >
Change tank Labels.
2. Select the type of tank you want to label.
3. Select Use Numbers.
Labeling Tanks as Names
1. From the Home screen, select Configure > Communications > NMeA 2000 Setup > Label Devices >
Change tank Labels.
2. Select the type of tank you want to label.
3. Select Choose Names.
4. Select a tank.
5. Select the location of the tank: Port (P), Center (C), Starboard (S), Fore (F), or Aft (A).
6. Select the label you want to use for the tank.
7. Repeat steps 4 through 6 to label additional tanks, if applicable, then select Done.
GPSMAP 4000/5000 Series Owner's Manual
®
Appendix
105