Hunter 47377 Owner's Manual page 34

5. SPAN 1: The next menu option is to set your thermostats primary span. Use the
or buttons to adjust between 1, 2, or, 3 degrees. Press
"Updated" and return to menu options or press
The span setting regulates when and how long your system will run. The span
has been set at the factory to 1 which will allow the system to turn on 1F (0.5
above or below the set temperature and run for 1
set temperature.
Example: If your thermostat is set to turn on at 72
of 2, your thermostat will activate your furnace at 70
72 . For cooling at 72
O
and shut down at 71
running time while 3 will lengthen it.
6. SPAN 2: Unless you have a multi-stage conventional or heat pump system, there
is no need to change the second stage span. If you do, use the
adjust between 1, 2, or, 3 degrees. Press
you need to make no changes. Second stage span acts the same as your primary,
but it determines when and how long your second stage heat runs.
7. TEMP F/C: The thermostat can change your temperature reading between
Fahrenheit and Celcius. Use the
(F) and Celsius (C) Press
options or press
34
Menu Options
with a span of 2, your air conditioner will activate at 74
O
. This setting can be changed to 1, 2, or 3. 1 will shorten your
O
, the screen will flash "Updated" and return to menu
Next
to return the the home screen.
Done/
Home
44118-01 • 08/06/2012
to return to the home screen.
Done/
Home
F (0.5
O
in heat mode, with a span setting
O
and shut it down when it reaches
O
once this has been changed or if
Done/
Home
or buttons to switch between Fahrenheit
, the screen will flash
Next
C) above or below the
O
or buttons to
C)
O
O