Stanley GT23 User Manual page 11

Stanley gt23 hydraulic power unit
Table of Contents

Advertisement

6. BATTERY
The supplied 12 Volt DC battery is a non-spillable, mainte-
nance-free battery and is fully charged.
Make sure the battery cables are tight and charging circuit
functions are operating properly.
Do not charge the battery with a standard auto-
motive battery charger. This type of charger pro-
duces a charging amperage higher than 2 amps.
Charging the battery at higher than 2 amps will
damage the battery.
If the engine runs out of gas or dies during op-
eration and the ignition switch is left in the ON or
RUN position, this could drain the battery. Make
sure the ignition switch is returned to the OFF
position.
OPERATION
GT23 User Manual 11

Advertisement

Table of Contents
loading

Table of Contents