10Replicating Your Setup; 11Dual-State Power Button - HP Business Desktop d500 Series Service & Reference Manual

Desktop Management
3.3.10 Replicating Your Setup
This procedure gives an administrator the ability to quickly and easily copy one setup
configuration to other computers of the same model. To replicate the setup:
1. Access the Computer Setup Utilities (F10) menu.
2. Click File > Save to Diskette. Follow the instructions on the screen.
This requires a diskette drive or a supported USB flash media device, such as DriveKey.
3. To replicate the configuration, click File > Restore from Diskette, and follow the
instructions on the screen.
System Software Manager (SSM) may also be used to distribute setup configurations to multiple
computers. For more information, see
3.3.11 Dual-State Power Button
With Advanced Configuration and Power Interface (ACPI) enabled for Windows 2000 and
Windows XP, the power button can function either as an on/off switch or as a suspend button.
The suspend feature does not completely turn off power, but instead causes the computer to enter
a low-power standby. This allows you to quickly power down without closing applications and to
quickly return to the same operational state without any data loss.
To change the power button's configuration, complete the following steps:
1. In Windows 2000, left click on the Start Button, then select Settings > Control Panel >
Power Options.
In Windows XP, left click on the Start Button, then select Control Panel > Performance
and Maintenance > Power Options.
2. In the Power Options Properties, select the Advanced tab.
3. In the Power Button section, select the desired power button setting.
After configuring the power button to function as a suspend button, press the power button to put
the system in a very low power state (suspend). Press the button again to quickly bring the system
out of suspend to full power status. To completely turn off all power to the system, press and hold
the power button for four seconds.
CAUTION: Do not use the power button to turn off the computer unless the system is not responding;
Ä
turning off the power without operating system interaction could cause damage to or loss of data on the
hard drive.
3–6
http://www.hp.com/go/ssm
336492-003
.
Service Reference Guide, d500