How To Use The Memory Function; Instructions For Special Conditions - Omron 705IT Instruction Manual

START
Continue to press button
10
When the measurement is complete, the cuff
completely deflates and your blood pressure and
pulse rate are displayed.
NOTE :
The monitor automatically stores blood pressure
and pulse rate into the memory.
• When 28 sets of readings are stored in memory,
the oldest set will be deleted to store a new set.
Press the (O/I) button to turn the monitor off.
NOTE :
If you forget to turn the monitor off, it will
automatically shut itself off after five minutes.

Instructions for special conditions:

• If your systolic pressure is known to be more than
220 mmHg, press and hold the (START
until the monitor inflates 30 to 40 mmHg higher
than your suspected systolic pressure.
NOTE :
Do not apply more pressure than necessary.
The monitor will not inflate above 300 mmHg.
How to use the
memory
function
) button
• To delete all the stored readings, press the (
NOTE :
This monitor has a memory capable of storing 28
sets of readings. Every time you complete the
measurement, the monitor automatically stores blood
pressure and pulse rate.
• Turn on the monitor by pressing the (O/I) button.
• Press the (
while the ( ) symbol is displayed.
Date and Time of stored readings
will be alternately displayed.
and the (START ) button simultaneously.
You can not delete the stored readings partially.
START
Press these two buttons
at the same time.
English
) button to recall stored readings
) button
11