TDC
11 5 640
Removing and installing conrod
•
Turn crankshaft to TDC position.
•
Lock the clutch housing with special tool,
BMW No. 11 5 640.
•
Remove conrods.
L
Note:
Conrods can also be removed and installed with the
crankshaft removed.
e
Caution:
Make sure that conrods and bearing shells are rein-
stalled in their original positions.
Use a felt-tipped pen or similar to mark the installed
positions on the conrods.
•
Install conrods.
11 2 500
e
Caution:
Oil the bearings.
•
Screw the big end bolts in by hand, then tighten
them with a tightening angle indicator,
BMW No. 11 2 500.
e
Caution:
Never re-use the big end bolts.
X
Tightening torque:
Big end bolts oiled
Joint torque.................................................. 20 Nm
Wrench angle .................................................... 80°
RS110210
11.31