Cisco 6500 Series Software Configuration Manual page 480

Understanding How NDE Works
Table 33-4 NDE Version 7 Flow Record Format (continued)
Bytes Content Description
42–43 dst_as Autonomous system number of the
destination, either origin or peer
44 src_mask Source address prefix mask bits
45 dst_mask Destination address prefix mask bits
46–47 pad2 Pad 2
48–51 MLS RP IP address of MLS router
1. Supported in Release 12.1(13)E and later releases.
2. With the destination flowmask, the "Next hop router's IP address" field and the "Output interface's SNMP ifIndex" field might not contain information
that is accurate for all flows.
MLS Cache Entries
NDE captures statistics for Layer 3-switched flows in the MLS cache on the PFC.
NDE maintains traffic statistics for each active flow in the MLS cache and increments the statistics when
packets within each flow are switched. Periodically, NDE exports summarized traffic statistics for all
expired flows, which the external data collector receives and processes.
Exported NetFlow data contains statistics for the flow entries in the MLS cache that have expired since
the last export. Flow entries in the MLS cache expire and are flushed from the MLS cache when one of
the following conditions occurs:
•
•
For flows that remain continuously active, flow entries in the MLS cache expire every 32 minutes to
ensure periodic reporting of active flows.
NetFlow data export packets go to the external data collector either when the number of recently expired
flows reaches a predetermined maximum, or every second, whichever occurs first.
By default, all expired flows are exported unless filtered. With a filter configured, NDE only exports
expired and purged flows that match the filter criteria. NDE flow filters are stored in NVRAM and are
not cleared when NDE is disabled. See the
NDE filter configuration procedures.
Sampled NetFlow
Sampled NetFlow exports data for a subset of the Layer 3-switched IP packets instead of for all packets
in a flow. Sampled NetFlow substantially decreases the Supervisor Engine 2 CPU utilization. Release
12.1(13)E and later releases support sampled NetFlow on the Supervisor Engine 2.
With the full-interface or destination-source-interface flow masks, you can enable or disable sampled
NetFlow on each LAN port. With all other flow masks, sampled Netflow is enabled or disabled globally.
Catalyst 6500 Series Switch Cisco IOS Software Configuration Guide—Release 12.1 E
33-6
The transport protocol indicates that the connection is completed.
Traffic inactivity exceeds 15 seconds.
Flow masks:
• X=Populated
• A=Additional field (see the
Fields" section on page 33-10)
Destination
Destination Source
A A
X X
"Configuring NDE Flow Filters" section on page 33-15
Chapter 33 Configuring NDE
"Populating Additional NDE
Destination
Source
1
Interface Full
A A
X X
Full
1
Interface
A
X
for
78-14099-04