Transom Shower Water System Trouble Shooting
Apply the following procedure to troubleshoot any water problem.
Table 3.4. Transom Shower Trouble Shooting Chart
Using The Transom Shower
Always keep the fresh water tank full. A full water
tank helps keep the water potable. To fill the tank:
1. Ensure that the water is supply is suitable for
showering.
2. Remove the filler cap and fill the tank until water
flows from the vent.
3. Secure the filler cap.
4. You will need to start the system if the tank has
been emptied to remove air from the supply
lines.
5. Sanitize the system as previously described in
this manual.
6. Energize the pressure pump
a. The boat must have electrical power to
energize the pressure pump with the boat's
battery.
b. Turn on the water pressure switch on the
helm switch panel.
7. Open the transom shower fixture until you empty
the air from the system.
8. Refill the water tank and turn off the pressure
pump
3-33
Systems
Figure 3-38. Water Tank, Hose, Filter, Pump, Shower
3-33