Refitting The Cover - Britax Chaperone User Manual

64 Care and Maintenance

Refitting the Cover:

1 Route the upper portion of the
cover over the infant carrier
shell.
* Be careful not to damage the
EPS foam.
3 Replace the buckle by turning
the metal buckle retainer so
the short side will fit through
the slots in the cover and
infant carrier shell.
IMPORTANT: Your infant carrier has been assembled with the buckle
strap in the inner position, and the harness straps adjusted to the inner
strap loops for infants weighing less than 5 kg (11 lbs). Once your child
reaches 5 kg (11 lbs) re-route the buckle position to the outer slot and
adjust the harness straps to the end loops for the remainder of use with
that child. Follow the procedures below to adjust the buckle position.
See pages 49 – 52 for instructions on removing and replacing the
buckle and adjusting the harness strap loops.
2 Pull the harness straps, chest
clips, and buckle tongues
through the slots in the cover.
4 Push the buckle strap retainer
through the desired slot in the
infant carrier shell and cover to
the bottom of the infant carrier
shell.
6
Check that the buckle strap
is not twisted and that the red
release button faces out.
8 Route the lower part of the
cover over the child seat
shell.
Care and Maintenance 65
5
Pull the buckle away from the
infant carrier to ensure the
buckle strap retainer lies flat
against the infant carrier shell.
7
Pull the adjuster strap through
the slot in the cover.