Lap-Shoulder Belt Installation - Britax Chaperone User Manual

24 Installing the Base

Lap-Shoulder Belt Installation

Before You Begin:
Remove the infant carrier before
9
installing the base.
9 Ensure that the lower connectors
are in the storage slots in the base.
Check that your vehicle seat belt
9
is compatible with infant carrier
use. See pages 11 – 15 for more
information.
1 Position the base in the desired
vehicle seating position.
3 Pull the vehicle belt out and
route the lap portion under
both belt guides.
Base Installation with Lap-Shoulder
belt
2 Open the lock-off by lifting the
tabs, and then lifting the lock-
off plate.
4 Verify that the vehicle belt is
not twisted and then buckle.
5 Push the base firmly into the
vehicle seat and remove all
slack from the lap portion of
the vehicle belt.
7 Hold the shoulder belt tight
and close the lock-off plate
over the vehicle belt.
9 Place the infant carrier into
the base and press down until
a click is heard.
* Pull up on the carrier handle to
confirm attachment.
Installing the Base 25
6 Pull the shoulder part of the
vehicle belt tight and then
route under both belt guides.
8 Press firmly on the lock-off
plate, and then close both
lock-off tabs.