Britax Chaperone User Manual page 23

42 Installing Your Infant Carrier without Base
8 Buckle the vehicle belt.
* The vehicle belt should be tight
around the infant carrier. If it
is not tight, unbuckle the belt,
remove the locking clip, and
repeat steps 2 – 7.
10 Verify that all connections are secure. Check that:
9 The vehicle belt is not twisted.
The vehicle belt is tight and locked.
9
* Ensure that a locking clip has been properly installed.
The infant carrier handle is rotated into any locked position.
9
The infant carrier is secure.
9
* If the infant carrier can be moved more than 2.5 cm (1 in.) front-to-back
or side-to-side at the vehicle belt path, repeat installation or choose
another seating location.
11 Check the recline angle.
9 Adjust the infant carrier handle
to any locked position.
Installing Your Infant Carrier without Base
12 The proper recline angle
is achieved when the level
indicators on the infant carrier
are within the level lines.
NOTE : It may be necessary to install and uninstall the infant carrier
more than once to achieve the proper recline angle. The vehicle should
be parked on a level surface.
Follow the steps below if adjustment of the recline angle is
necessary:
a
Unbuckle the seat belt.
b
Place a rolled towel or pool
noodle in the vehicle seat bight.
* See note below.
Repeat the previous steps until a secure installation with proper
recline angle is achieved. Continue with installation instructions from
step 2 on page 40.
NOTE : Configure pool noodle(s) to accommodate variations in
vehicle seat contour as necessary.
43
c
Place the infant carrier on the
towel or pool noodle to help level
the base.