Using The R-88 As An Audio Interface; Block Diagram For Audio Interface Connection - Roland R-88 Owner's Manual

Using the R-88 as an Audio Interface

The audio input from the R-88 can be recorded via USB into software on your computer. At the same time, recording and playback can be carried out
on the R-88.
* USB audio interface functionality is not available when the sampling rate is 192 kHz.
* If DIGITAL IN is selected as the input, or if TIMECODE MODE is set to EXT SYNC or EXT SYNC AUTO REC, the audio input may be interrupted for
some devices. If the audio input is interrupted, either avoid using DIGITAL IN, or set TIMECODE MODE to something other than EXT SYNC or EXT
SYNC AUTO REC.
* The audio interface will operate at the sampling rate that is specified by the SAMPLE RATE setting in REC/PLAY SETUP. You cannot play back a
project of a sampling rate different than this setting.

Block Diagram for Audio Interface Connection

INPUT
IN 1–8
PFL 1–8
PLAYER
TRACK 1–8
2MIX
REC/
PLAY
SLATE
MIC/TONE
to PC from PC
REC/
PLAY
Direct
Monitor SW
Connecting to Your Computer via USB
FROM PC/
TO PC
MIXER
CH 1–8
2MIX
MIC/TONE
RECORDER
TRACK 1–8
2MIX
MIC/TONE
OUTPUT
OUT 1–8
2MIX
MIC/TONE
MONITOR
PFL 1–8
2MIX
63