Verifying The Ip Settings; Configuring For Pull Printing - Lexmark C750 Setup Manual

Verifying the
IP settings
Note:
On Windows computers,
click Start Programs
Command Prompt.
Configuring for
Pull Printing
6
Change the address by pressing
each number. Press
when you are finished.
Select
The message Saved appears briefly.
7
Press Menu until you see Set IP Netmask, and then press
Select.
8
Repeat step 6 to set the IP Netmask.
9
Press Menu until you see Set IP Gateway, and then press
Select.
10
Repeat step 6 to set the IP Gateway.
11
When you are finished, press
Ready state.
1
Print another network setup page. Look under the "TCP/IP"
heading and make sure the IP address, netmask, and gateway
are what you expected.
See "Printing a network setup page" on page 42 if you need
help.
2
Ping the printer and verify that it responds. For example, at a
command prompt on a network computer type "ping" followed
by the new printer IP address:
ping xxx.xxx.xxx.xx
If the printer is active on the network, you should receive a
reply.
If your printer has an optional ImageQuick firmware card installed, it
can be configured for Pull Printing once an IP address has been
assigned.
For detailed configuration instructions, refer to the CD that shipped
with the ImageQuick card.
to increase or decrease
Menu
to move to the next segment. Press
Select
to return the printer to the
Go
Configure for TCP/IP
45