Verifying The Ip Settings; Configuring For Pull Printing (Imagequick) - Lexmark W820dn Setup Manual

Verifying the
IP settings
Configuring for
Pull Printing
(ImageQuick)
98
Configure for TCP/IP
6
Change the address by pressing
decrease) each number. Press
segment. Press
The message Saved appears briefly.
7
Press until you see Set IP Netmask, and then press
Menu
.
Select
8
Repeat step 6 to set the IP Netmask.
9
Press until you see Set IP Gateway, and then press
Menu
.
Select
10
Repeat step 6 to set the IP Gateway.
11
When you are finished, press
Ready state.
1
Print another network setup page and make sure the IP
Address, Netmask, and Gateway are what you expected.
Use the information in "Printing a network setup page" on
page 93 if you need help.
2
Ping the printer and verify that it responds. For example, at a
command prompt on a network computer type "ping" followed
by the new printer IP address:
ping xxx.xxx.xxx.xx
If the printer is active on the network, you should receive a
reply.
If your printer has an optional ImageQuick™ firmware card installed,
you can configure for Pull Printing once an IP address has been
assigned to the printer.
For detailed configuration instructions, refer to the online
documentation on the ImageQuick CD. The ImageQuick CD is
shipped with printers that have the ImageQuick optional firmware
card pre-installed, and also with the firmware card if you purchased it
separately.
Menu
Select
when you are finished.
Select
to return the printer to the
Go
to increase (or
to move to the next