6. Menu functions
Main menu entry vehicle
You can perform the following entries in
this main menu.
Enter Out beginning / end
If you use the vehicle for a journey outside
of the scope of the regulations, you can set
the function to "Out of Scope" and/or end
it again.
Select the following functions step by step.
1.
entry
vehicle
2.
vehicle
OUT begin
vehicle
OUT end
The setting "Out of Scope" ends automat-
ically as soon as you insert a driver card
into card slot 1 or withdraw a driver card
from slot.
© Continental Automotive GmbH
Enter Beginning of ferry / train
Select the ferry / train specific condition,
when you are about to drive on to the ferry
/ train or when you have just parked up on
the ferry / train.
Select the following functions step by step.
1.
entry
vehicle
2.
vehicle
ferry/train
3. Then set your current activity using
key
.
The recording of the port operation is auto-
matically ended as soon as a one-minute
driving period has been recorded by the
DTCO 1381.
The "" symbol is no longer dis-
played when the vehicle is moving.
The display is shown again however
when the vehicle stops before one
minute of driving time is recorded by
the DTCO 1381.
Main menu entry vehicle
Set Local time
Read and understand the chapter
"Time management" before
attempting to make any changes!
Refer to "Time management" on
page 82.
Select the listed functions step by step.
1.
entry
vehicle
2.
vehicle
local time
3.
UTC 27.03.2013
23:32
23:32
UTC 29.03.2013
00:02
23:32
UTC 29.03.2013
23:32
00:32
In the standard display, you may adjust the
time to the local time zone as well as to the
beginning or end of daylight-savings time
in steps of ±30 minutes.
6
61