7510
Printhead shutter motor assembly
1. Remove the rear cover assembly. See
2. Remove the rear left middle cover. See
3. Remove the MPF feed unit assembly. See
4. Remove the printer left door assembly. See
5. Remove the registration transport roll assembly. See
page
4-46.
6. Disconnect the connector from the printhead shutter motor assembly (A).
7. Remove the two screws securing the printhead shutter motor assembly (A) to the machine.
8. Remove the printhead shutter motor assembly (A) from the machine.
4-78
Service Manual
Mounting hook
B
"Rear cover assembly removal" on page
"Rear left middle cover removal" on page
"MPF feed unit assembly removal" on page
"Printer left door assembly removal" on page
"Registration / transport roll assembly removal" on
C
4-5.
4-6.
4-8.
4-36.
Previous
Next
Go Back