Dodge Caliber 2012 Owner's Manual page 35

Automatic Unlock Doors On Exit Programming
The Automatic Unlock Doors On Exit feature can be
enabled or disabled as follows:
• For vehicles equipped with the EVIC, refer to "Elec-
tronic Vehicle Information Center (EVIC)/Personal
Settings (Customer-Programmable Features)" in "Un-
derstanding Your Instrument Panel" for further infor-
mation.
• For vehicles not equipped with the EVIC, perform the
following procedure:
1. Close all doors and place the key in the ignition.
2. Within 15 seconds, cycle the ignition switch between
LOCK and ON/RUN and then back to LOCK five times
ending up in the ON/RUN position (do not start the
engine).
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 33
3. Within 30 seconds, press the power door UNLOCK
switch to unlock the doors.
4. A single chime will indicate the completion of the
programming.
5. Repeat these steps if you want to return this feature to
its previous setting.
NOTE:
• If you do not hear the chime it means that the system
did not enter the programming mode and you will
need to repeat the procedure.
• Use the Automatic Unlock Doors On Exit feature in
accordance with local laws.
I n f o r m a t i o n P r o v i d e d b y :
2