Table of Contents
Advertisement
3.1.4 Searching for services
Searching every service of a satellite
3. Enter the position of your selected satellite to the Satellite
Angle option if it is not correct.
4. Select the Goto the position option, then the antenna will
turn toward your selected satellite as calculating its po-
sition.
5. If the receiving quality, which is displayed at the bottom
right of the screen, is not good, then tune the antenna
finely with the Move option. The changed position is
automatically saved. At this time you had better check
the receiving quality of every transponder and choose
the best one at the Transponder (or Frequency) option.
It will be helpful to your fine tuning.
There are in general four service search methods:
• searching every service of a satellite,
• searching every service of a transponder,
• searching single service of a transponder,
• searching every service of a SMATV (Satellite Master An-
tenna Television) system.
To search every service of a satellite, take the following steps:
3.1 Searching for broadcasting services 21
To perform a service search, se-
lect the Installation > Searching
menu. You should see a screen
like the left figure.
Advertisement
Table of Contents
