Step 9: Configure For Tcp/Ip; Assigning A Printer Ip Address - Lexmark C752 Setup Manual

Step 9: Configure for TCP/IP

Assigning a printer
IP address
Note:
Instructions for other
methods of setting the IP
address are in the online
documentation on the
drivers CD that shipped with
your printer. Launch the CD,
click View Documentation
Network Printer Install.
If you have TCP/IP available on your network, we recommend that you
assign an IP address to the printer.
If your network is using DHCP, an IP address is automatically assigned
after you connect the network cable to the printer.
1
Look for the address under the "TCP/IP" heading on the
network setup page you printed in "Printing a network setup
page" on page 53.
2
Go to "Verifying the IP settings" on page 55 and begin with
step 2.
If your network is not using DHCP, then you must manually assign an
IP address to the printer.
One of the easiest ways is to use the operator panel:
1
Press until you see Network Menu, and then press
Menu
2
Press until you see Standard Network, and then press
Menu
.
Select
Standard Network appears if you purchased a printer with a
network port on the printer system board. If you have a MarkNet
print server installed in the option card, you see Network Option
1.
3
Press until you see Std Net Setup (or Network 1 Setup),
Menu
and then press
4
Press until you see TCP/IP, and then press
Menu
5
Press until you see Set IP Address, and then press
Menu
6
Change the address by pressing
each number. Press
when you are finished.
Select
The message Saved appears briefly.
Configure for TCP/IP
54
.
Select
Menu
to move to the next segment. Press
Select
Select
.
Select
Select
to increase or decrease
.
.