AMX MVP-7500 Operation/Reference Manual page 62

Setup Pages
Setup Page (Cont.)
Connection Status:
Display Timeout:
Display Timeout on
Battery Power
(MVP-8400 only)
Inactivity Page Flip
Timeout:
Panel Brightness:
(MVP-8400 only)
LCD Control:
(MVP-7500 only)
52
Displays whether the panel is communicating externally as well as the encryption
status of the Master, the connection type (Ethernet or USB), and what System the
panel is connected to.
• Until a connection is established, the message displayed is: "Attempting via...".
• When a connection is established, the message displayed is either: "Connected
via Ethernet "or "Connected via USB ".
• The word "Encrypted" appears when an encrypted connection is established with
a NetLinx Master.
Note: The panel must be rebooted before incorporating any panel communication
changes and to detect Ethernet connections.
Indicates the length of time that the panel can remain idle before activating Sleep
mode (causing the LCD to power down).
• Press the UP/DN buttons to increase/decrease the Display Timeout setting.
Range = 0 - 240 (minutes).
• Set the timeout value to zero to disable Sleep mode.
Note: Small timeout values maximize the life of the battery charge.
When enabled, this button allows the device to engage Display Timeout when the
device has been removed from a charging station and is running solely on battery
power. When disabled (the button goes dark), Display Timeout is not engaged, and
the device will continue to run at full power until it is returned to a charging station
or the device's battery is depleted.
Indicates the length of time that the panel can remain idle before automatically flip-
ping to a pre-selected page.
• Press the UP/DN buttons to increase/decrease the Inactivity Page Flip Timeout
setting. Range = 0 - 240 (minutes).
• Set the timeout value to zero to disable Inactivity Page Flip mode.
Note: The touch panel page used for the Inactivity page flip is shown within a small
Inactivity Page field.
Sets the display brightness level of the panel.
• Press the UP/DN buttons to adjust the brightness level. Range = 0 - 100.
Note: The on-screen bargraph can be dragged to adjust the brightness level which
is then reflected as a numeric value in the Panel Brightness field.
Sets the display brightness and contrast levels of the panel.
• Press the Brightness UP/DN buttons to adjust the brightness level.
Range = 0 - 100.
• Press the Contrast UP/DN buttons to adjust the contrast level. Range = 0 - 100.
MVP Modero ViewPoint Touch Panels