Lexmark 258x Technical Reference page 12

Draft document
Table 1-5: Ids - Dec 197, 198 (Hex C5, C6) (Sheet 1 of 9)
Parm Description Dec
1 Emulation 0
1
2
3 - 255
2 Panel Disable 0
1
2
Note: Specific buttons can be enabled during Panel Disable mode. The upper 6 bits of parm 2 represent the different buttons
on the operator panel as below.
Bit
7. Font
6. Pitch
5. Micro up
4. Micro down
3. LF
2. Macro
3 Macro 0
1
2
3
4
5 - 254
255
Notes:
• Macro 1 is the original macro that is backward compatible. Macros 2-4 were added to provide additional flexibility when
changing between alternate form sizes. Disable macro is functionally the same as Macro 1.
If init = dec 4, 5 (hex 04, 05) are specified, parm 3 is ignored.
If init = dec 0, 1, 254, 255 (hex 00, 01, FE, FF) are specified, parm 3 value is used as Macro No. instead of Default Macro
setting No.
If init = dec 254, 255 (hex FE, FF) are specified, parm 3 value is overwritten to Default Macro setting in NVRAM. If the
disable (=255) is set to parm 3 Macro No. 1 setting is used to initialize.
• "No change" indicates the printer will retain the current macro. All parameters will overwrite the NVRAM of the current
macro.
Hex Action for Id = Dec 197 / Hex C5 Action for Id = Dec 198 / Hex C6
00 No Change
01 PPDS
02 EPSON
03 - FF No Change
00 No change
01 Panel Disable
02 Panel Enable
OFF
Disabled
Disabled
Disabled
Disabled
Disabled
Disabled
00 No change
01 Macro 1
02 Macro 2
03 Macro 3
04 Macro 4
05 - FE No Change
FF Disable Macro
1-6
SIC Command
No Change
PPDS
EPSON
No Change
No change
Panel Disable
Panel Enable
ON
Enabled
Enabled
Enabled
Enabled
Enabled
Enabled
No change
Macro 1
Macro 2
Macro 3
Macro 4
No Change
Disable Macro