Setting Top-Of-Form In A Macro - Lexmark 2500 User Manual

4
Open the control panel cover to access layer 2.
5
Press any paper movement button (Micro , Micro , LineFeed) to align the horizontal lines located on the platen
with the Top-Of-Form you want.
Note: If you press and hold a paper movement button, the paper will advance in micro movements and then
go into continuous feed mode.
6
Press Set TOF to set and save your Top-Of-Form.
7
Close the control panel cover.
8
Press Start/Stop to put the printer online.

Setting Top-Of-Form in a macro

Each macro has a separate Top-Of-Form setting. To set Top-Of-Form in a macro, you must first select that macro.
1
Open the control panel cover to access layer 2.
2
Press Macro to select the macro you want to use.
Note: The procedure for setting Top-Of-Form depends on the paper and print mode you are using. For help, see
one of the following sections in this chapter:
•
"Setting Top-Of-Form for continuous forms in push mode" on page 40
•
"Setting Top-Of-Form for continuous forms in pull mode" on page 41
•
"Setting Top-Of-Form for a cut form or an envelope" on page 41
Loading paper
42