Screw And Retainer Identification Table - Lexmark C734dn Service Manual

Screw and retainer identification table

The following table contains screw types and retainers, locations, and quantities necessary to service the
printer. Pay careful attention to each screw type location when doing removals. You must install the correct
screw type in each location during reassembly.
Sizes are as close to actual as possible, as long as the printout is not scaled or resized.
Screw identification table
P/N Screw type
10B1580 #6 panhead
1126828 E-clip M3
1126829 E-ring M4
18B0832 Taptite M3 L6
panhead
Location
Cartridge cooling fan to top cover
Cooling fan to top cover
LR overcenter bellcrank to side frame
MP feeder gears to right side frame studs
5 V interlock switch to right frame
Card support plate to upper plate
Card support plate to lower plate
Card support plate (and printhead ground) to left frame
Card support plate to right frame
Cartridge left guide assembly to left plate (interior side of plate assembly)
COD (color-on-demand) drive assembly to upper plate
COD shaft assembly to upper plate
Contacts assembly to left frame next to auger worm gear
Contacts assembly to left frame near duct
EP drive to right plate (exterior side)
Front door ground wire to right frame bracket
HVPS to left frame plate
5026
Qty
2
2
1
2
1
2
3
5
4
4
3
2
2
2
8
1
1
Repair information
4-3
Previous
Next
Go Back