Storage Areas; Glove Box; Resetting Defaults - Chevrolet 2004 Venture Owner's Manual

Reprogramming a Single HomeLink
Button
To program a device to HomeLink
button previously trained, follow these steps:
1. Press and hold the desired HomeLink
Do not release the button.
2. The indicator light will begin to flash after
20 seconds. While still holding the HomeLink
button, proceed with Step 2 under "Programming
®
HomeLink ."

Resetting Defaults

®
To reset HomeLink to default settings do the following:
1. Hold down the two outside buttons for about
20 seconds until the indicator light begins to flash.
2. Continue to hold both buttons until the HomeLink
indicator light turns off.
3. Release both buttons.
For questions or comments, contact HomeLink
at 1-800-355-3515, or on the internet at
www.homelink.com.
2-52
®
® ®
using a HomeLink
®
button.
®
®
®

Storage Areas

Your vehicle's large carrying capacity can store many
items. If you have the extended wheelbase version, you
can carry even larger items. You can also use the
floor pins that are used to attach the seats, to secure
larger loads.

Glove Box

Your vehicle has a glove box below the instrument
panel. To open the glove box, lift the latch release.
The glove box door has a detent to prevent the door
from lowering too far. Open the glove box until the door
is partway open, then pull the door down if you need
it fully open. To close the glove box, the door must
be pushed up past the detent.