Advertisement
Remove the dome cover
Step2
Remove the screw that secures the dome cover holder
and the enclosure. Rotate the dome cover holder coun-
terclockwise until the dome cover holder can be
removed.
You can remove the dome cover holder, light-blocking
sheet, and dome cover (in this order) once the 3 protru-
sions on the enclosure are lined up with the notched
areas of the dome cover holder. (Do not remove the
case ring.)
The screw, dome cover holder, and light-blocking sheet
will be used again in step 3.
Replace the dome cover
Step3
1 Remove the cover film from the outside of the dome cover (WV-CF5SA). Keep the removed cover
film for future use. (Take care not to damage the outside or inside of the dome cover.)
2 Attach the dome cover (WV-CF5SA) to the enclosure. When attaching, align the 3 notched areas
on the dome cover with the 3 protrusions on the case ring.
3 Attach the light-blocking sheet and dome cover holder removed in step 2 to the dome cover from
the top, and then rotate the dome cover holder clockwise and secure it using the screw from step
2. (The recommended tightening torque: 0.39 N·m {0.29 lbf·ft})
4 Attach the cover film removed in 1 to the surface of the dome cover.
Dome cover holder
Light-blocking sheet
Dome cover
Notched areas on
the dome cover
Case ring
Protrusions on
the case ring
2
Protrusions on
the enclosure
Notched areas on the
dome cover, and protru-
sions on the case ring
Screw
Dome cover holder
Advertisement
